12-pin AUX adapter with Lightning charging cable, for MFD3, RCD 210, RCD 310, RCD 510, RNS 310, RNS 510 and RNS-E

If you currently do not have an AUX connection on your factory car radio, this is the solution.
This cable is connected to the AUX connection of your original Audi / Seat / Skoda / Volkswagen car radio with active AUX functionality using the 12-pin plug.
Your Apple device remains charged at the same time thanks to the 8-pin Lightning connector.

If you can switch your car radio to the AUX input, then this AUX cable can be used.
If this is not the case, the AUX functionality will not be activated by using this cable.
To do this, you can go to the dealer to have the AUX functionality activated (if supported by your car radio) or purchase a Yatour interface that does not require the active AUX functionality.

The necessary AUX connection is located on the back of the radio.
The following disassembly keys (usually 2x sets) can be used to disassemble the radio:

https://www.carinterface.nl/radio-demontage-hulpstuks/radio-demontage-hulpstuk_yt-key02




The installation is quite simple. The white 12-pin connector of the AUX cable / audio adapter is connected to the AUX port on the back of the car radio.
Then the black wire of the AUX cable must be connected to -12V (ground). No AUX mass!
Possibly to drain the radio housing.

Please check that the AUX port on your car radio visually matches the connector on this cable before placing the order!